Foppa skrev:forsberg skrev:3 inlägg å fortfarande inget svar
enklare å ringa eller maila TATS så får du reda på vad det ska vara i den... typ å antal liter...
Eller allra enklast kollar man i bruksanvisningen, foppa du skriver inte om det är manuell eller automat?, så här står det i 2002års bruksanvisning:
Capacities and Specifications
The following approximate capacities are given in English and metric conversions. Please refer to “Recommended Fluids and Lubricants”
in the Index for more information.
Automatic Transmission
Drain and Refill . . . . . . . . . . . . . . 5.0 quarts (4.7 L)
Overhaul . . . . . . . . . . . . . . . . . 10.8 quarts (10.2 L)
Cooling System . . . . . . . . . . . . . . 12.6 quarts (11.9 L)
Engine Oil with Filter . . . . . . . . . 6.5 quarts (6.1 L)
Fuel Tank . . . . . . . . . . . . 18.5 U.S. gallons (70.0 L)
Manual Transmission
(Overhaul) . . . . . . . . . . . . . . . . . 4.1 quarts (3.8 L)
Wheel Nut Torque . . . . . . . . . . 100 lb-ft (140 N·m)
All capacities are approximate. When adding, be sure
to fill to the appropriate level, as recommended in this
manual. Recheck fluid level after filling.
Part D: Recommended Fluids and Lubricants
Fluids and lubricants identified below by name, part number or specification may be obtained from your dealer.
USAGE FLUID/LUBRICANT
Engine Oil The engine requires a special engine oil meeting GM Standard GM4718M. Oils meeting this standard may be identified as synthetic, and should also be identified with the American Petroleum Institute Certified for Gasoline Engines starburst symbol. However, not all synthetic API oils with the starburst symbol will meet this GM standard. You should look for and use only an oil that meets GM Standard GM4718M. For the proper viscosity, see “Engine Oil” in the Index.
USAGE FLUID/LUBRICANT
Engine Coolant 50/50 mixture of clean, drinkable water and use only
GM Goodwrench DEX-COOL or Havoline DEX-COOL Coolant. See “Engine Coolant” in the Index.
Hydraulic Brake System
Delco Supreme 11 Brake Fluid (GM Part No. 12377967 or equivalent DOT-3 brake fluid).
Windshield Washer Solvent
GM Optikleen Washer Solvent (GM Part No. 1051515) or equivalent.
Hydraulic Clutch System
Hydraulic Clutch Fluid (GM Part No. 12345347 or equivalent DOT-3 brake fluid).
Power Steering System
GM Power Steering Fluid (GM Part No. 1052884 - 1 pint, 1050017 - 1 quart, or equivalent).
Manual Transmission
DEXRON-III Automatic Transmission Fluid.
Automatic Transmission
DEXRON-III Automatic Transmission Fluid.
Key Lock Cylinders
Multi-Purpose Lubricant, Superlube (GM Part No. 12346241 or equivalent).
Rear Axle (Limited-Slip Differential)
SAE 75W-90 Synthetic Axle Lubricant (GM Part No. 12378261 or equivalent) meeting GM Specification 9986115. With a complete drain and refill add 4 ounces (118 ml) of Limited-Slip Axle Lubricant Additive (GM Part No. 1052358 or equivalent) where required. See “Rear Axle” in the Index.
Hood Latch Assembly, Secondary Latch, Pivots, Spring Anchor and Release Pawl Lubriplate Lubricant Aerosol (GM Part No. 12346293 or equivalent) or lubricant meeting requirements of NLGI # 2, Category LB or GC-LB.
Hood and Door Hinges
Multi-Purpose Lubricant, Superlube (GM Part No. 12346241 or equivalent).
WeatherstripConditioning
Dielectric Silicone Grease (GM Part No. 12345579 or equivalent).
What Kind of Engine Oil to Use
Look for two things:
GM4718M
Your vehicle’s engine requires a special oil meeting GM Standard GM4718M. Oils meeting this standard may be identified as synthetic. However, not all synthetic oils will meet this GM standard.
You should look for and use only an oil that meets GM Standard GM4718M.
SAE 5W-30
As shown in the viscosity chart, SAE 5W-30 is best for your vehicle. However, you can use SAE 10W-30 if it’s going to be 0F (-18C) or above.
These numbers on an oil container show its viscosity, or thickness. Do not use other viscosity oils such as SAE 20W-50.
Oils meeting these requirements should also have the starburst symbol on the container.
This symbol indicates that the oil has been certified by the American Petroleum Institute (API). You should look for this on the oil container, and use only those oils that are identified as meeting GM Standard 4718M and have the starburst symbol on the front of the oil container.
Your vehicle’s engine is filled at the factory with a Mobil 1 synthetic oil, which meets all requirements for your vehicle.
Substitute Engine Oil: When adding oil to maintain engine oil level, oil meeting GM Standard GM4718M may not be available. You can add substitute oil designated SAE 5W-30 with the starburst symbol at all temperatures. If temperatures are above 0F (-18C), you may substitute SAE 10W-30 with the starburst symbol. Substitute oil not meeting GM Standard GM4718M should not be used for an oil change.
Det var väl svar på ett par av dina frågor, detta har även varit uppe massvis med gånger tidigare. En sökning borde ge svar.
mvh/Stefan
